My Account 0 Favorites 0 Items 0 Basket 0  Items /  0,00
{ "@context":"http://schema.org/", "@type":"BreadcrumbList", "itemListElement": [{"@type":"ListItem","position":1,"item":{"@id":"\/en\/","name":"Home"}},{"@type":"ListItem","position":2,"item":{"@id":"\/en\/paints-varnishes\/","name":"Paints & Varnishes"}},{"@type":"ListItem","position":3,"item":{"@id":"\/en\/paints-varnishes\/varnishes-lacquer-paints\/","name":"Varnishes & Lacquer Paints"}},{"@type":"ListItem","position":4,"item":{"@id":"https:\/\/www.orex.de\/en\/paints-varnishes\/a-63210376\/","name":"Vectra floor coating liquid plastic 750 ml"}}] }
Vectra floor coating liquid plastic 750 ml
Vectra floor coating liquid plastic 750 ml -55%
Vectra floor coating liquid plastic 750 ml 1

Vectra floor coating liquid plastic 750 ml

  • Item number: J532336F
  • Manufacturer: Vectra
Vectra Logo
-55% You save: 10,49 €
RRP: €18.98
€8.49
(Base price: €11.32/liter) incl. tax + shipping**
(ready for shipping 1-3 working days)

Vectra liquid plastic floor coating glossy 750 ml


Vectra liquid plastic is ideally suited as a floor coating for indoor and protected outdoor areas. The liquid plastic has a semi-gloss finish and can be diluted with water. The product is easy to apply, dries quickly and is both tread-resistant and weather-resistant. The liquid plastic is resistant to water and standard household cleaning agents.

Application:

Vectra liquid plastic can be used in hobby or basement areas, as well as for covered balconies. It can also be used in exhibition and storage areas that are not subject to traffic. It is not suitable for garage floors. The product can be diluted with water, but the water content should not exceed 30% (30 ml water to 100 ml varnish). Stir the paint well before use. The paint can then be applied with a paint roller or brush.

New coat: Apply this product diluted with 30 % water. To do this, pour the material into an empty container and mix with the water while stirring evenly.
Top coat: Apply this product undiluted in 2 coats.
Renovation coat: Completely remove flaking and unstable old coats down to the substrate and then treat as a new coat.

Before each coat, lightly sand and clean the substrate after drying.

Substrate:

Plaster, concrete, masonry, screed, sound old coats of paint

Substrate preparation:

  • the surface to be painted must be clean, dry, free of dust and grease, firm and load-bearing
  • Completely remove cement slurry, lime deposits, oxide layers or release agents and rinse thoroughly
  • Allow new concrete surfaces to dry for at least 4 - 6 weeks
  • Sand and clean old coats that are in good condition
  • Remove non-load-bearing, flaking coatings without leaving any residue
  • the substrate must be protected from rising damp

Drying (depending on substrate and environment):

Surface dry: after approx. 4-6 h
Can be painted over: after approx. 12 h
Can be walked on: after 24 h
Fully loadable: after 7 - 10 days

  • Container size: 0.75 l
  • Colour: see selection, glossy
  • Area of application: Interior, protected exterior
  • Consumption: approx. 160 ml/m² = approx. 6m²/l
  • Properties: Tread-resistant, load-resistant, abrasion-resistant, very good adhesion, high hiding power, resistant to common household chemicals, paint and primer in one

$('.item-id-input-field').hide().find('input').val('63210376')