My Account 0 Favorites 0 Items 0 Basket 0
Items /
0,00 Suggestions
No search results.
Items
No search results.
Categories
No search results.
Suggestions
No search results.
Items
No search results.
Categories
No search results.
LECO Painter's Glass non-woven Plus Aqua is a glass non-woven coated/primed white on both sides with a factory-applied, water-activated paste finish and is versatile due to its properties. It is ideal for smoothing and consolidating interior wall and ceiling surfaces as well as for renovating and refurbishing load-bearing substrates. It can also be used to bridge cracks in cracked or crack-prone substrates. Due to its high-quality primer, it is particularly suitable for use in the commercial sector, as an evenly absorbent paint absorption is guaranteed. This saves time and labour. In addition, the glass non-woven is dimensionally stable, rot-proof and free of PVC, solvents and plasticisers.
The substrate must be dry, of the same colour, clean and load-bearing. Old wallpaper and water-swellable coatings must be removed. Cracks, joints and unevenness must be professionally filled with gypsum-based levelling compounds. Pre-treat highly absorbent substrates with deep primer. Cut the strips to the required length, adding 5-10 cm to compensate for the top and bottom edges. Pull the wallpaper through the aqua unit and fold it into loops. The applied paste activates within approx. 1 minute, for ceiling bonding approx. 2-3 minutes activation time is necessary. Do not leave the fabric in the water bath. Apply the strips butt-jointed or with a double-seam cut and press down with a wallpaper spatula until bubble-free. Carefully press the excess into the corners and cut off along the trimming ruler with a sharp cutter knife. When using the double-seam cut, lay strips approx. 3-5 cm overlapping and cut through both strips vertically without damaging the substrate. Remove strips and press cut edges. Remove adhesive on the visible side completely immediately with a damp cloth or sponge. Do not apply below 8°C room/wall temperature. After drying, paint over with dispersion, latex or acrylic paints, as desired and depending on use.
Suitable accessories
5
4
3
2
1
Loading reviews...
Delete review
My account
We use cookies and similar technologies on our website and process personal data of visitors to our website (e.g. IP address), e.g. to personalise content and advertisements, to integrate media from third-party providers or to analyse access to our website. Data processing only takes place when cookies are set. We share this data with third parties that we name in the settings.
Data processing may be carried out with consent or on the basis of a legitimate interest. Consent can be given or refused. There is a right not to consent and to change or withdraw consent at a later date. We provide more information about the use of personal data and the services in our Privacy policy.